Hi guys
I am planning to use PIC18F27K40, it is absolutely necessary to use DT_INTS-18
for the project. I will also use low priority interrupts. I have seen several
modifications of DT_INTS-18 to cope with these chips but I am uncertain of
which one to use. The versions I have run in to are DT_INTS-18-K40, DT_INTS-18_3_4b
and DT_INTS-18_3_4c. How well are they tested? As I understood there were some
issues with low priority interrupts. In one thread I read about DT_INTS-18_3_4c
but the link to the software was not working. If this is the one, does anyone
have this code?
Best regards
Lasse
I am planning to use PIC18F27K40, it is absolutely necessary to use DT_INTS-18
for the project. I will also use low priority interrupts. I have seen several
modifications of DT_INTS-18 to cope with these chips but I am uncertain of
which one to use. The versions I have run in to are DT_INTS-18-K40, DT_INTS-18_3_4b
and DT_INTS-18_3_4c. How well are they tested? As I understood there were some
issues with low priority interrupts. In one thread I read about DT_INTS-18_3_4c
but the link to the software was not working. If this is the one, does anyone
have this code?
Best regards
Lasse