Hi all,
To the best of my knowledge the only difference between the PIC16F and the PIC16LF is the input power that they can take. Where the PIC16F part can take a higher Vin than the other part. Am I correct on this? Is there any other difference that I should know about?
The issue comes in that I programmed a bunch of PIC16F1939 with a HEX file generated in Microcode Study with a PIC16LF1939 set as the PIC to be programmed. My circuit is working with Vin = 3V, so that the voltage is ok for both chips. The chips PIC16F1939 seem to be working ok, but I'm concerned that the PIC16LF1939 generated HEX file might cause any problems. Any help and comments will be appreciated.
Thank you for your help,
Robert
To the best of my knowledge the only difference between the PIC16F and the PIC16LF is the input power that they can take. Where the PIC16F part can take a higher Vin than the other part. Am I correct on this? Is there any other difference that I should know about?
The issue comes in that I programmed a bunch of PIC16F1939 with a HEX file generated in Microcode Study with a PIC16LF1939 set as the PIC to be programmed. My circuit is working with Vin = 3V, so that the voltage is ok for both chips. The chips PIC16F1939 seem to be working ok, but I'm concerned that the PIC16LF1939 generated HEX file might cause any problems. Any help and comments will be appreciated.
Thank you for your help,
Robert