So Im stumped over this one. Using a PIC16F1936 on a lighting project. Trying to run some simple code to blink A.7, A.6, C.0, C.1, C.2,
.. All lights are blinking except PortA.7.
RA.6 and RA.7 are also oscillator pins and must be set to I/O outputs in CONFIG1 with CLKOUTEN=1 (_CLKOUTEN_OFF) and FOSC= INTOSC (CLKOUTEN_OFF). According to the data sheet this should give digital I/O on both RA.6 and RA.7. RA.6 is responding as expected. RA.7 is NOT giving me a digital output. I have tried on multiple 1936s on my design board and LAB-X2. No 5V output on RA.7. What have I overlooked?
Thanks,
Wayne
Code:
; MPASM
asm
__config _CONFIG1,_FOSC_INTOSC & _CLKOUTEN_OFF & _MCLRE_ON & _BOREN_OFF & _WDTE_OFF & _FCMEN_OFF & _CP_OFF & _CPD_OFF & _IESO_OFF
__config _CONFIG2, _WRT_OFF & _PLLEN_OFF & _STVREN_ON & _BORV_LO & _LVP_OFF
endasm
define osc 8
;--[ Set Hardware ]---------
OSCCON=%01110000
ANSELA=$0
ANSELB=$0
ADCON0=$0
PortA=0
PortB=0
PortC=0
TrisA=0
TrisB=0
TrisC=0
Start:
PortA.7=1
pause 500
PortA.6=1
pause 500
PortC.0=1
pause 500
PortC.1=1
stop
ENDThanks,
Wayne