Hi guys ,
i am about to start using the interrupt priority of interrupts on a 18f67k22. for timer 0 , timer 1, timer 2,
where timer 0 is low priority , timer 1 high , timer 2 low ,
this chip incorporates a high/ low level priority for most of the interrupt sources and was wondering if using DT_IN_18LP.bas does the same thing as setting up the registers manually or do i need to do both ?
Regards
Sheldon.
i am about to start using the interrupt priority of interrupts on a 18f67k22. for timer 0 , timer 1, timer 2,
where timer 0 is low priority , timer 1 high , timer 2 low ,
this chip incorporates a high/ low level priority for most of the interrupt sources and was wondering if using DT_IN_18LP.bas does the same thing as setting up the registers manually or do i need to do both ?
Regards
Sheldon.